|read(n)||Tcl Built-In Commands||read(n)|
read channelId numChars
ChannelId must be an identifier for an open channel such as the Tcl standard input channel (stdin), the return value from an invocation of open or socket, or the result of a channel creation command provided by a Tcl extension. The channel must have been opened for input.
If channelId is in nonblocking mode, the command may not read as many characters as requested: once all available input has been read, the command will return the data that is available rather than blocking for more input. If the channel is configured to use a multi-byte encoding, then there may actually be some bytes remaining in the internal buffers that do not form a complete character. These bytes will not be returned until a complete character is available or end-of-file is reached. The -nonewline switch is ignored if the command returns before reaching the end of the file.
Read translates end-of-line sequences in the input into newline characters according to the -translation option for the channel. See the fconfigure manual entry for a discussion on ways in which fconfigure will alter input.
- read channelId numChars
- In this form read blocks until numChars have been received from the serial port.
- read channelId
- In this form read blocks until the reception of the end-of-file character, see fconfigure -eofchar. If there no end-of-file character has been configured for the channel, then read will block forever.
set fl [open /proc/meminfo] set data [read $fl] close $fl set lines [split $data \n]