CoDel - Controlled-Delay Active Queue Management algorithm
tc qdisc ... codel [ limit PACKETS ] [ target TIME ] [
interval TIME ] [ ecn | noecn ] [ ce_threshold
CoDel (pronounced "coddle") is an adaptive "no-knobs" active
queue management algorithm (AQM) scheme that was developed to address the
shortcomings of RED and its variants. It was developed with the following
goals in mind:
o It should be parameterless.
o It should keep delays low while permitting bursts of traffic.
o It should control delay.
o It should adapt dynamically to changing link rates with no impact on
o It should be simple and efficient and should scale from simple to complex
CoDel comes with three major innovations. Instead of using queue size or queue
average, it uses the local minimum queue as a measure of the
standing/persistent queue. Second, it uses a single state-tracking variable of
the minimum delay to see where it is relative to the standing queue delay.
Third, instead of measuring queue size in bytes or packets, it is measured in
packet-sojourn time in the queue.
CoDel measures the minimum local queue delay (i.e. standing queue
delay) and compares it to the value of the given acceptable queue delay
target. As long as the minimum queue delay is less than target
or the buffer contains fewer than MTU worth of bytes, packets are not
dropped. Codel enters a dropping mode when the minimum queue delay has
exceeded target for a time greater than interval. In this
mode, packets are dropped at different drop times which is set by a control
law. The control law ensures that the packet drops cause a linear change in
the throughput. Once the minimum delay goes below target, packets are
no longer dropped.
Additional details can be found in the paper cited below.
hard limit on the real queue size. When this limit is reached, incoming packets
are dropped. If the value is lowered, packets are dropped so that the new
limit is met. Default is 1000 packets.
is the acceptable minimum standing/persistent queue delay. This minimum delay is
identified by tracking the local minimum queue delay that packets experience.
Default and recommended value is 5ms.
is used to ensure that the measured minimum delay does not become too stale. The
minimum delay must be experienced in the last epoch of length interval.
It should be set on the order of the worst-case RTT through the bottleneck to
give endpoints sufficient time to react. Default value is 100ms.
can be used to mark packets instead of dropping them. If ecn has been
enabled, noecn can be used to turn it off and vice-a-versa. By default,
ecn is turned off.
sets a threshold above which all packets are marked with ECN Congestion
Experienced. This is useful for DCTCP-style congestion control algorithms that
require marking at very shallow queueing thresholds.
# tc qdisc add dev eth0 root codel
# tc -s qdisc show
qdisc codel 801b: dev eth0 root refcnt 2 limit 1000p target 5.0ms interval
Sent 245801662 bytes 275853 pkt (dropped 0, overlimits 0 requeues 24)
backlog 0b 0p requeues 24
count 0 lastcount 0 ldelay 2us drop_next 0us
maxpacket 7306 ecn_mark 0 drop_overlimit 0
# tc qdisc add dev eth0 root codel limit 100 target 4ms interval 30ms ecn
# tc -s qdisc show
qdisc codel 801c: dev eth0 root refcnt 2 limit 100p target 4.0ms interval
Sent 237573074 bytes 268561 pkt (dropped 0, overlimits 0 requeues 5)
backlog 0b 0p requeues 5
count 0 lastcount 0 ldelay 76us drop_next 0us
maxpacket 2962 ecn_mark 0 drop_overlimit 0
o Kathleen Nichols and Van Jacobson, "Controlling Queue Delay", ACM
CoDel was implemented by Eric Dumazet and David Taht. This manpage was written
by Vijay Subramanian. Please reports corrections to the Linux Networking
mailing list <firstname.lastname@example.org>.